4–60 mm · footprint unchanged
Five-pocket open-bottom 3D printed tray with rounded bottle openings and four compliant edge pads.Loading 3D model…
Drag to rotate · pinch to zoom
Rigid footprint
216 × 112 mm
Wall height
20 mm
Retention
5 openings · 4 pads
Fit-check thickness
2.4 mm

The 219 ± 2 mm drawer width and pocket footprints are estimated from one photograph, referenced against two cards and the elevated ruler. Bottle undersides are partially obscured. Digital mesh checks are complete; native X1C slicing and physical fit are not verified. Print the thin fit-check first.

Design dimensions and tolerances

Open-bottom walls allow the bottles to rest on the drawer floor. Five rounded openings keep them separated without enclosing their lids. Four slotted pads extend the nominal 216 mm span by up to 1.4 mm per side (218.8 mm overall), allowing limited lateral compliance. Opening entrances grow 0.8 mm over the final 0.8 mm height in two steps; there is no support-requiring upper roof.

OpeningClearance footprint
Montblanc, transverse38 × 102 mm
Montblanc, longitudinal105 × 38 mm
Montblanc, square50 × 61 mm
Square bottle50 × 61 mm
Parker52 × 80 mm

Exported meshes use a 0.5 mm XY sampling grid, so nominal dimensions can deviate locally by up to 0.5 mm. The PDF includes a literal-size layout and a 100 mm check ruler; print at 100%, with page scaling disabled.

Printing and verification

The STL and 3MF links export the currently selected wall height; their browser-generated meshes use the same source triangles as the viewer. The 3MF contains a single centred bed-oriented mesh for a nominal 256 × 256 mm plate, not a sliced Bambu project. The source ZIP and printed drawing use the 20 mm default. The model is open-bottom, with its entire underside on the print bed. PLA is adequate for a low-cycle fit-check; PETG has better tolerance for repeatedly flexed side pads. Nozzle, filament shrinkage and printer tuning change the actual fit.

The standalone generator produces two closed, connected meshes with consistent facet orientation and positive volume; the STEP and sliced G-code claimed in the earlier prototype response were not retrievable and are not included. Actual native Bambu Studio off/normal/tree support checks, G-code, adhesion, interference, and lifetime testing remain outstanding. Do not force bottles into a tight fit.

Geometry and assumptions · Editable OpenSCAD source · Fit-check STL · Model notes