# Ink drawer tray - digital prototype

Fit reference: one photograph with 2 card-sized calibration objects and an elevated tape.
Five low, open-bottom pockets retain the bottles without enclosing their lids.
Rigid body 216 x 112 x 20 mm; compliant pads extend nominal width to 218.8 mm.

Files: ink-tray.stl / ink-tray.3mf / ink-tray.scad; fit-check.stl / fit-check.3mf;
drawing.pdf (100% template), validation.json. 3MF contains geometry in a centered
256 mm build-plate layout, but it does not contain sliced G-code, printer presets,
or claims about supports or physical fit.

The nominal pocket footprints are estimates. Print the fit-check to evaluate
bottle footprint and drawer width, then adjust the CAD parameters if required.
The mesh is rasterized at 0.5 mm XY and front-top opening relief is approximated
by 0.4 mm steps. The STEP and native X1C sliced project from a prior answer were
not accessible; do not represent either as included or verified.

No personal or card information from the calibration photograph is published.
