Plan view of five-compartment UPLIFT accessory tray, fitted across the drawer width.Loading model…
Drag to rotate · pinch to zoom · Print plate uses the 256 × 256 mm X1 Carbon bed
Footprint
194 × 205 mm
Height
26 mm
Compartments
5 · one-piece print
Bed
256 × 256 mm

The mesh is closed, consistently wound, one continuous solid, and fits inside the X1C plate. All 130 geometric sections at 0.20 mm contain valid outlines; no downward-facing faces exist above the bed. Native Bambu Studio slicing, support toolpaths, and physical fit are not verified. The original accessory tray dimensions and mounting details are unpublished; this is a photo-based fit candidate.

Dimensions and fit
DimensionDrawer STR006Printed tray
Width203.2 mm (8 in), conservative194 mm
Depth426.7 mm (16.8 in)205 mm occupied
Height88.9 mm (3.5 in)26 mm

The accessory tray spans nearly the full drawer width but only part of its front-to-back depth. The front of the cabinet is on the left in the supplied photograph. UPLIFT's drawing shows 8.5 in width while its specification table says 8 in. The model reserves 9.2 mm total nominal clearance from the smaller published width. That difference does not establish the true retaining-rail fit or the tray's own dimensions, which must be measured.

Cabinet product page · Manufacturer specifications

Print and model details

Print the single part flat, floor down. PLA, a 0.4 mm nozzle and 0.20 mm layers are the starting process. The model has a continuous 2.0 mm floor, a 2.4 mm perimeter, a 26 mm outside wall, and 20 mm dividers. All five compartments open upwards. Geometry needs no bridges or roofs and has 0.0 mm of designed unsupported downward-facing surfaces.

The printable file is an unsliced 3MF, not a Bambu Studio project containing generated G-code. It places the model at x=31–225 mm and y=25.5–230.5 mm on the 256 mm bed. Digital validation reports exact mesh hashes, cross-section checks and the remaining native-slicer and physical-fit gates. A paper silhouette or partial fit coupon is recommended before a full print because the factory tray was not measured.